Plant Trays

These plant trays can accommodate up to 5.5" nursery pots but can be scaled to virtually any size. The raised ridges in the center of the tray allow for even runoff while watering your plants.

Supports

Infill

Layer Height

Material

No

15%

0.15mm

PETG

Cable Storage

This design allows you to wind up your cables for organization and storage. Insert one hand into the inside ring to hold it in place. Attach your cable and rotate the outer ring to wind up the cable.

Supports

Infill

Layer Height

Material

No

5%

0.15mm

PETG

Filter Wall Mount

This design allows you to mount a HEPA (intake) or Carbon (exhaust) filter to your wall.

Supports

Infill

Layer Height

Material

No

15%

0.2mm

PLA

Wood Rod Wall Mount

These mounts are designed to accept wooden rods with a diameter of 1 3/8". The center mount is to add stability for longer rods.
Hardware Used:
1" flat head wood screw #8.

Supports

Infill

Layer Height

Material

No

15%

0.2mm

PLA

Desktop Mountains

Height map data used in blender to create a mesh.
Featuring: Mount St. Helens, Mount Rainier, Mount Baker.

Supports

Infill

Layer Height

Material

No

10%

0.2mm

PLA

Hotshoe Flashlight
Adapter

Adapter ID is 30mm.
Design Hardware:
M3 x 0.5mm x 20mm socket head screw
M3 x 0.5mm Nut

Supports

Infill

Layer Height

Material

No

10%

0.2mm

PETG

Ducting Accessories

These ducting accessories are designed to give you more control over the airflow in your indoor garden. The Intake will change the airflow direction from a vertical flow to a horizontal flow and diffuse the air evenly over the garden floor. The Exhaust has bar mounts on all 4 sides. Each mount accepts one zip tie which will allow it to mount flush on bars up to 2 inches in diameter. Both adapters are scaled to fit 4in diameter ducting but can be scaled up to fit 6in, 8in and beyond depending on your printer size.

Supports

Infill

Layer Height

Material

Yes

5%

0.2mm

PETG